Samsung CLP-315 / CLP-315W Samsung CLP-320 / CLP-320K / CLP-320N Samsung CLP-325 / CLP-325N / CLP-325W Samsung CLP-360 / CLP-365. 161, Samsung phone usb driver windows, 651422. Elan driver update for elan input device windows 10. 12844, >:(, Driver toolkit keygen generator, 5049. 66156, Xerox workcentre 3045b proshivka chipa,.

CLP-360 / CLP-365 CLP-360W / CLP-365W Firmware version available to reset remotely 3.xx.01. 16 Price: 1 4EUR / 15,4$ 19EUR / 21,8$ + ** Note Firmware version 3.00.01. 02.xx can’t be reset remotely, only New: Available now for reset remotely – Transfer Belt reset – Image Unit reset – Fuser Life reset – T ransfer Roller Life reset – Pick-up Roller Life reset Necessary: – remote connection through / Cost 15EUR/17,5$ 30% discount [ 10,5EUR/12,2$] purchased with fix firmware reset chip on the cartridges! For more details! ——————————————————————————————————————————————————————————————————————————————————————————– Solve error replace or install waste toner container.

Start by removing the cartridges by pulling the handle on the left and right side of the cartridge. Then, remove the box marked with 'YMCK' by pulling it towards to you. Then, there's a handle on the bottom of the printer (with a barcode sticker). Pull it and wiggle it towards to you until it pops out ( DO NOT LIFT UP! Only pull forward!!) Now set the cartridges and photo drum somewhere safe and cat/dog/kid-free. It is ideal to turn down the light level a bit so the photosensitive coating is not degrading.

Toner might be harmful if ingested or inhaled. Photosensitive coating contains heavy metal. Do not let your children or your pets play with it.

If you happened to spill some of the toner, use damp cloth to wipe it off. Do not use hot water. If your clothings are stained by the toner, use cold water and sticky tape to get rid of toner stain. NEVER USE HOT WATER. Do not tumble dry. Grab your smartphone or a trusty torch (FLASHLIGHT.

Not gas torch! If you use open flame inside the printer, it might damage it or cause explosion.) Look into the glossy black plastic film inside the printer, just above the spot where the green cylinder was sitting on.

If it's dirty, take a DRY lint-free cloth (like a glasses towel) and wipe it softly until there's no leftover toner or dust left on the film. DO NOT TOUCH THE SURFACE WITH YOUR FINGERS OR PRESS IT DOWN. It WILL damage the surface of the film and WILL cause irreversible loss of printing quality. Teni ambera mech haosa dzhon betankur 4 kniga.

If it's not dirty, look at the green cylinder you just pulled out on the previous step. DO NOT SHINE BRIGHT LIGHT ONTO IT.

It will shorten the lifespan of the photosensitive imaging drum. If it's dirty, press on the sheared gear (white plastic) on the right side of the drum, careful not to touch the surface of the drum, and wipe the drum with lint-free cloth. Repeat the process to all sides after turning the gear towards to you. There's a reason for this step.